If your LG washer displays the IE error code, it means the machine isn’t filling with water properly. Don’t worry—this is a common issue and often easy to resolve without needing a repair technician. Whether you’re a homeowner or renter, this guide will walk you through what the LG washer IE error means, what causes it, and how to fix it step-by-step.

What does the IE Error code mean?

The IE code stands for Inlet Error. It appears when your LG washing machine is not filling with water within the expected time.

Common causes include:

• Closed or partially open water supply valves

• Kinked or frozen water hoses

• Clogged inlet filters inside the washer

• Low water pressure

• Faulty water inlet valve

• In rare cases, a problem with the control board or pressure sensor

The good news is, most of these can be checked and fixed at home with a few simple tools.

Step-by-step troubleshooting guide

1. Check the Water Supply Valves

Make sure both the hot and cold water valves connected to your washer are fully open. A partially turned valve can significantly slow or stop water flow, triggering the IE error.

2. Inspect the Inlet Hoses

• Check for kinks, bends, or twists in the hoses that may block water flow.

• If it’s cold outside, ensure the hoses aren’t frozen, especially if the washer is in a garage or basement.

• Detach each hose and run water into a bucket to test flow.

3. Clean the Inlet Filters

Inside the water inlet ports (where the hoses attach to the washer), there are small mesh filters that trap debris.

• Turn off the water supply and unplug the washer.

• Carefully remove the hoses from the back of the machine.

• Use needle-nose pliers or tweezers to gently pull out the filters.

• Rinse them under running water to remove dirt or mineral buildup.

• Reinsert and reconnect the hoses securely.

4. Run a Test Cycle

Plug the washer back in and run a short wash or rinse cycle.

• If water enters the drum and the IE error clears, your fix worked!

• If not, continue to the next step or consider calling a technician.

Safety Tip: Always unplug your washer before inspecting internal components or removing panels.

When to call a technician

While most IE errors are caused by minor clogs or hose issues, there are cases where professional help is needed:

• The water inlet valve is not opening when the washer is on

• There’s no water flow despite full pressure at the source

• The control board or pressure sensor is malfunctioning

• Internal wiring may be damaged or disconnected

If you’ve tried all the basic troubleshooting steps and your LG washing machine still won’t fill with water, it’s time to contact a certified appliance repair technician.

How to prevent IE Errors in the future

Avoid repeat problems by following these maintenance tips:

• Clean inlet filters every few months to prevent debris buildup

• Use the washer only when water pressure is stable

• In winter, insulate hoses or disconnect them if the washer is in a cold area

• Always follow the manufacturer’s loading guidelines to ensure proper operation

These small steps can extend the life of your machine and prevent fill issues.

Conclusion

The LG washer IE error means your machine isn’t filling with water, usually due to a blockage, filter issue, or valve problem. Fortunately, most causes can be quickly resolved at home with basic tools and a few minutes of your time. If the problem persists, don’t hesitate to call a technician for a safe, lasting repair.